adevries17's avatar
adevries17
npub1653c...y7uw
adevries17's avatar
adevries17 11 months ago
If I were Linus, I would change the version of the kernel to 7.0 and all subsequent kernels would be 7.X forever. Why? Because why not, I'm Linus. In all seriousness, I do not know enough to make a good decision regarding the direction the kernel should take or what adjustments to make. That is why I'm not Linus...
LINUX Unplugged • 603: All Your Kernels Belong to Rust • Listen on Fountain
There have been major Rust developments in the Linux Kernel; we discuss what's new and how it will impact the future. Plus, we're joined by a speci...
 View quoted note →
adevries17's avatar
adevries17 11 months ago
If family computer counts, the first computer I remember using and learning was a dell dimension 5000. Keep in mind I'm only only 10ish years older than your oldest... Sorry to make you feel old lol The first computer that was actually mine was a custom built machine centered around an A10-7890K because I was too poor for a dedicated video card at the time. This was during high school so what money I did get from the job I had was saved up and I later bought a 1050ti.
Fountain
The Launch 🚀 • 11: Eggsistential • Listen on Fountain
Wes joins us so Chris can finally get some answers. Also, a legendary community creation rises again, and we uncover the truth about renting living...
 View quoted note →
adevries17's avatar
adevries17 11 months ago
A few weeks ago I mentioned I might get a prusa core one. Well I have. It should ship this month hopefully. Now I've began going down the rabbit hole of filaments. Alex what do you primarily print with? Any good brands, places to get it, things to look out for? Any tips or "I wish I knew this before" advice? I'm a total newb so any and all help is appreciated https://fountain.fm/show/LxGQPEpBqTDLxF4d6qC5 View quoted note →
↑